EPMAN Turbocharger Turbine Exhaust Stainless Steel Clamp V-Band CHRA Turbo Flange 95mm Flange for Toyota CT26 CT20 EP-HFQ950

Product in category: Exhaust System - V band clamp and hose clamp

EPMAN Turbocharger Turbine Exhaust Stainless Steel Clamp V-Band CHRA Turbo Flange 95mm Flange for Toyota CT26 CT20 EP-HFQ950

Stock: In Stock
Reward Points: 2
Model: EP-HFQ950
Weight: 0.25kg

Based on 0 reviews. - Write a review

$2.60

20 or more $2.50

Qty

Add to Cart

Buy Now Ask Question

Add to Wish List Compare this Product

Description
Reviews

You are buying on 100% Brand New of:

EPMAN Turbocharger Turbine Exhaust Stainless Steel Clamp V-Band CHRA Turbo Flange 95mm Flange for Toyota CT26 CT20 EP-HFQ950

Contents:

1 x Turbine Housing Clamp (includes fixing bolt and nut)

Specification:

Torque Rating: 5NM

Outside Diameter: ø109mm

Assembled (Flange)Size: ø95mm

Flange Clamping Thickness: 16mm

Application:

For Mitsubishi TD07 Turbo

For TOYOTA CT20 CT26 Turbo

For T51R, T04Z, AX75F

- Clamp between cartridge and turbine housing (amongst others) with an 95mm V-band flange.

This clamp is used to clamp up the V-band style flanges of the bearing housing and the turbine housing flanges of the CT20/CT26 turbochargers, as well as many other applications with the below dimensions:

These clamps are complete and include fixing bolt and nut.

Correct fitting of a V-band clamp is vital for correct operation and to ensure you do not suffer premature failure.

CORRECT TIGHTENING OF YOUR V-BAND CLAMP:

V-Band clamps are NOT tightened excessively. They are designed to pinch the mating flanges together whilst allowing movement through expansion and vibration. Over-tightening can damage clamps, flanges and, in the worst case scenario, pipe work.

To mount your V-Band clamp, put mating flanges together and fit clamp. Tighten clamp to a torque setting of 3.5 Newton Metres (NM). Then, using a rubber mallet, tap around the mating flanges to allow the joints to fully centre and sit without any unequal load. Then increase torque to its final torque setting of 5 Newton Metres (NM).

Further tapping with a rubber mallet to remove any uneven load from the clamp or flange is beneficial, whilst checking the torque setting stays at its rating of 5 Newton Metres (NM).

All items are Brand New unless stated otherwise on the listing. We sell DIY (Do It Yourself) Items with a few exceptions. We take no responsibility in teaching you how to install. Professional installation is strongly recommended.